I'm afraid the 'Select' part doesn't really help.
If you open the door and look down the sides of the door there should be a rating plate with a model number. This should start with AHY, ADP or APL as Dave says above.
[quote="RWESTFOLD@OXTED.SURREY.SC"]:oops: DO NOT NO MODEL NO BUT IT IS A HYGENA SELECT IS THIS ANY HELP ITS ABOUT FOUR YEARS OLD BROUGHT FROM M F I [u
possible wiring loom fault take door panel off and check wiring in door. if not take the anti flood chamber off the water valve if the machine fills you will require a lower air trap on left hand side of unit
Model number will be on a label around the edge of the door, starting AHY----.
As these dishwashers come from several different sources, the number is critical to any form of accurate diagnosis of the problem. Sufficed to say that if the machine is not filling and puts the heater on, it thinks that it is already full........
Pull the plug before any internal investigations .
Which bit of "Unplug it" is causing the problem?
Stop eMailing me. This is a perfectly good forum - use it!
I also have a same type of fault as described above. Model APL 8214(details below)... Was there a solution to this problem??
As well as the machine not filling, the timer doesn't appear to be turning either. If you turn it around to a wash cycle the element will start heating up but that's about all. If you put it onto a rinse cycle absolutely nothing happens, no water, and again the timer doesn't 'click' around.