adamhornsby wrote:Back to main problem about the Hoover, does anyone know what is happening with it,
The thread has gone so seriously 'off topic' I've almost forgotten what your problem is?
"Overheating" eh? Whilst you may have done a continuity test of the thermostat it doesn't in fact have one of those but a Thermistor instead. Now the cheapest option at this stage would be to replace that, especially (by pressing the prewash button- If I recall correctly?) if reducing the pre-set temperature fails to change anything?
"Going on without ending" is a little more of a worrying as that could be a fault with the TMX Slave Unit? And if, when it plays up, it doesn't show an Error Code on the LED Display panel, then likely as not the TMX unit and the Control Module will be at fault I reckon?
Start with replacing the Thermistor I would and check you have full continuity from that right back to the module board connection. (duff connections can be a bugger to suss after all?)
Hope that helps?