Washing Machine Help Forum

machine wont dispence water , i close the door select settings from controller press start ,door lock comes on but water dose not go into soap dispenser i have check mains water supply all ok

Will the machine drain and spin?

starts a spin cycle then stops about one min. starts as if it is going to a full spin then stops door lock still on setting is 15 on front of machine does not seem to drain

Could be a faulty drain pump, quite common to get leaks onto the pump, can often lead to failure of the main PCB.

stevie w1 wrote:starts a spin cycle then stops about one min. starts as if it is going to a full spin then stops door lock still on setting is 15 on front of machine does not seem to drain

open circuit drain pump most likely

do you get cotinuity across the two spades of the drain pump

It depends on what you are testing it with but resistance should be around 160Ω to 180Ω.

tested with a fluke. pump goost . will order one cheers ,thanks for all the info hoover engineer wanted 169 pounds as my warrenty had just run out Being and old miserable heating engineer didnt want to part with that amoumt of money ..cheers

If you are lucky it will just be a faulty pump. Look closely for any signs of water ingress. It shouldn't really be happening so soon but the inlet hose from the dispenser to the drum can leak where it slots into the outer drum.

You should also make sure the replacement pump has an internal TOC, some don't and if the pump gets jammed they will often take out the main pcb if there is no overload protection.

wasnt lucky, got new pump ,fitted still no water at solnoids ,but drum would now spin. had to buy PCB. cheapest was candy/hoover to my suprise .PCB fitted machine working like a goodning still hate hoover thanks again for the advice iadom and seagull

stevie w1 wrote: still hate hoover

Perhaps you should direct your ire at Candy, thats what your machine is after all.