Dishwasher Help Forum

Hi, hope someone can help. We have a Belling IDW604 dishwasher which is about 4 years old. Generally been working fine. Few cycles this week didn't clean at all well. Looked at it yesterday realised filters hadn't been cleaned for ages, so did that. Went to use it today and it doesn't work for more than 1 minute. All looks OK to start with, select program, close door, usual initial sound which I think is the pump pumping out water. After a minute or so that sound goes and it doesn't then do anything else. When I open the door there is no error code displayed. Power and water supply are fine and as I say generally been working OK previously. I understand there may be a programmer reset necessary but I don't know if that will do the job, nor do I know how to do it.
Any ideas gratefully received.
Thanks
Steve and Sue

Its a bit of a long shot, but try pooring a kettle full of boiling hot water in the base of the machine, leave it for 10 mins, and then try it! we have done this in the workshop in the past, To be honest'it does not have a good success rate, but would be a cheap and easy repair if it works.

Sean.

And to be equally honest, if you have managed to get 4 years out of a low end Chinese made dishwasher you are already quids in, don't waste any serious money on it.