Moderators: r600a, johnmac11, eastlmark, Jackal, Del, Dave_Conway, don, iadom, Penguin45, Dales-Electronic
Spare parts for appliances from UK Whitegoods
by classicfordandy » Tue Jul 31, 2012 4:53 pm
Hi all thanks for any help in advance, I have a G1220SC that blows the fuse in the plug after 10-15mins into cycle I think I've seen F14 displayed but not 100% sure could this be linked? I have 29 ohms across the heater and have checked the main board out and am now stuck...
Thanks again for any replys.
-

classicfordandy
- Whitegoods Newbie

-
- Posts: 2
- Joined: Tue Jul 31, 2012 4:44 pm
by Seamy » Tue Jul 31, 2012 7:28 pm
F14 is heater level switch fault. Most likely its the circulation pump motor not putting up enough pressure, likely theres something stuck in the impellor. Check wiring, especially to & from heating relay & check reading of heater to earth.
-

Seamy
- Appliance Forum Veteran

-
- Posts: 1990
- Joined: Fri Dec 12, 2003 12:00 am
-
by classicfordandy » Mon Aug 06, 2012 11:51 am
Hi and thanks for your reply I have checked it out and now it runs without tripping. Set it to quick wash and it heats fine but when it gets to 14 mins left it pumps out and it sounds like an inlet solenoid is humming for 2 mins and just sits there till 1 min left pump comes on and off then end light comes on???? Ah help please.
-

classicfordandy
- Whitegoods Newbie

-
- Posts: 2
- Joined: Tue Jul 31, 2012 4:44 pm
Return to Dishwasher Help Forum
-
- Hotpoint - switch to drying cycle blows capacitor?
by Imagine70 » Mon Sep 20, 2010 7:16 pm
- 6 Replies
- 1057 Views
- Last post by iadom

Wed Nov 03, 2010 9:49 pm
-
- Hotpoint Aquarius blew the fuse during rinse cycle - help!
by bikerboy » Mon Dec 19, 2005 9:28 am
- 1 Replies
- 902 Views
- Last post by iadom

Mon Dec 19, 2005 9:55 am
-
- Hygena intergrated dishwasher blowing fuse and fuse box
by lmcc67 » Fri Aug 26, 2005 8:56 pm
- 17 Replies
- 2398 Views
- Last post by Penguin45

Sun Aug 28, 2005 11:13 pm
-
- Miele G 646 SC PLUS - wash/drain cycle sticking
by gpf » Sat Mar 18, 2006 9:07 pm
- 11 Replies
- 2977 Views
- Last post by jamie0114

Tue Aug 08, 2006 9:08 am
-
- Miele G692 SC Plus skipping steps in the cycle
by melevittfl » Sun Nov 07, 2010 9:48 am
- 1 Replies
- 716 Views
- Last post by Seamy

Tue Nov 09, 2010 9:09 am
Who is online
Users browsing this forum: No registered users and 14 guests