Beko 5 LED Washing Machine Fault Codes

This set of fault codes only pertains to the Beko WM series of washing machines but it may also relate to other Beko models that use the same PCB from Invensys for a controller and have five LEDs used. 

These error codes may not relate to ALL Beko WM series washing machines. If you are unsure please ask in the forums as well as for all other Beko washing machine fault codes.

Before you start any investigation of the fault or even remove the lid of the washing machine please read and fully understand this article in full and pay particular attention to the safety and information notices at the bottom of this page as they contain extremely important information!

Please remember to support our site by buying Beko washing machine spares from our spare part store and, if you decide that you really need an engineer please support the local repairers that help make this site possible, you can search for a repairer from theengineer search facility.

Beko 5 LED Washing Machine Fault Codes

These fault codes are written for washing machine repairers and not for the general public by Beko and they assume a certain level of competence on the part of the user in diagnostic routines. We have added some notes to try to assist you in determining the nature of the fault you have but, you will still need to investigate each failure on its own merits. For more help and advice on fault finding on a washing machine please refer to our washing machine fault finding guide from this link before you begin which will help you diagnose the problem with your Beko washing machine..

Please check that any Beko washing machine spares recommended are suitable for use on your particular model and serial number. If you are unsure about the suitability of any spare part please ask to ensure that you get the correct spares for your washing machine. Please, don't guess or assume as spares can be altered on a production run with the same model number having several different alternative components used.

Fault Code Lights Legend

This is our very simple legend to show the state of the lights, lamps or LED's as they are unlit, flashing or lit continuously.

Light or LED not lit Light or LED flashing Light or LED lit solid, no flash

Beko Washing Machine Fault Codes

The LEDs in these error codes represent the prewash, spin, rinse and then wash LED's as you look at them, being either lit or not lit, they should not be flashing.

H1

Light or LED on constantly when error displayed

Light off when error displayed

Light off when error displayed

Light off when error displayed

Light off when error displayed

NTC (thermistor) Open or Short Circuit

The washing machine has detected an error with the wash thermistor and is reporting this. The error can be caused by either a short circuit or the thermistor itself being open circuit.

  • Check wiring to thermistor
  • Check thermistor normally ~4700 Ohms @ 25˚C ambient

 

H2

Light off when error displayed

Light or LED on constantly when error displayed

Light off when error displayed

Light off when error displayed

Light off when error displayed

Heater detected open circuit

Ordinarily this is the indication of a simple heater failure however it may pay to check the wiring and thermistor.

  • Check wash heater for continuity
  • Check wiring to heater
  • Checck thermistor

 

H3

Light or LED on constantly when error displayed

Light or LED on constantly when error displayed

Light off when error displayed

Light off when error displayed

Light off when error displayed

Heater detected as always on

The wash heater is detected as being on constantly in the washing machine and the machine will abort and shut down.

  • Check wash heater
  • Check wiring
  • Check pressure or level sensor
  • Check heater relay on main control PCB

 

H4

Light off when error displayed

Light off when error displayed

Light or LED on constantly when error displayed

Light off when error displayed

Light off when error displayed

Water inlet valve triac short circuit

The electronic control module has detected a fault in the water inlet valve control triac, namely that it has a short circuit.

  • Check wiring to water valve
  • Check water valve
  • Check valve triac on the electronic control board

 

H5

Light or LED on constantly when error displayed

Light off when error displayed

Light or LED on constantly when error displayed

Light off when error displayed

Light off when error displayed

Drain pump detected open circuit

Ordinarily this will be indicative of a simple drain pump failure.

  • Check drain pump for continuity
  • Check wiring to drain pump

 

H6

Light off when error displayed

Light or LED on constantly when error displayed

Light or LED on constantly when error displayed

Light off when error displayed

Light off when error displayed

Motor triac short

The electronic controller has detected a short circuit on the motor control triac but there are other things to check.

  • Check wiring to motor
  • Check motor
  • Check motor control triac on main electronic board

 

H7

Light or LED on constantly when error displayed

Light or LED on constantly when error displayed

Light or LED on constantly when error displayed

Light off when error displayed

Light off when error displayed

Pressure sensor failure

This error is the electronic controller detecting that there is a failure of the pressure or level sensor however, it can also be caused by an errant reading or signal causing the failure to be detected.

  • Check wiring to pressure sensor
  • Check pressure sensor
  • Check connectors on main control board

 

H11

Light off when error displayed

Light off when error displayed

Light or LED on constantly when error displayed

Light or LED on constantly when error displayed

Light off when error displayed

Motor open circuit

This error can be caused by the motor being oppen circuit or the motor tacho being detected as open circuit. Both can be cause by wiring or connection issues.

  • Check wiring to motor
  • Check wiring to motor tacho
  • Check wiring from electronic controller to the motor
  • Check motor
  • Check motor tacho

More Help, Advice And Guidance On Beko Washing Machines

Should you need more help and guidance please use the links from this article as most of them will help you to understand your Beko washing machine a lot better and probably very much help you in diagnosing the fault you have. Of course there are many other articles on the site that will also help you do this.

In addition you can post in our help and advice forums after registering but please do pay heed to the information below before doing so and read the guides, they are there to help you.

You must understand certain things before you begin or attempt any repairs on your own and we want to make these points very, very clear to anyone that decides to investigate one of these or any other washing machines:

  • We are not responsible for your safety, you are and by using this guide you accept that and accept that any damage that you may cause and work undertaken is entirely at your own risk.
  • We will advise the common causes of the fault codes but we cannot guarantee that any parts or work recommended will resolve the issue. It is entirely your responsibility to diagnose your particular problem and resolve it.
  • We are not responsible for you buying spares that do not resolve the problem, this is down to your own diagnosis not ours.
  • No warranty is inferred, implied or given.
You also have to understand that fault or error codes are not a "magic bullet", they will not tell you what the problem is, they will only offer you an indication of where the problem lies and they are no substitute for good old fashioned diagnostic skills. You can find out more about what fault codes actually tell you in this article. So please be well aware that, even with this new found knowledge you will still have to actually be capable of investigating and diagnosing the problem and this means adhering to basic appliance safety for working on them. As, if you don't and tell the engineers in the forums that you hooked up components to a live feed, worked on a live appliance and so on they will be a whole heap less willing to help you in our washing machine forum because they will assume that you are trying to commit suicide and are not safe working on your machine.

Please do note that manufacturers can and do change fault codes without notice and we cannot guarantee that these error codes will apply to your particular model as all codes apply to a wide range of appliances and not normally any one specific model. To determine if these fault codes do apply to your particular Beko washing machine model please post a request to confirm this in the forums.

Add comment

Please do not use the comments box if you need the following.
With notes on where to get the best help at the end of each line:
Spares Help - From the store "Contact Us" option or spares@ukwhitegoods.co.uk
Technical Help & Support - Please use the forums
How To Repair Problems - Please use the forums


Security code
Refresh

 

Find Local Service Engineers

Find a domestic appliance service engineer to repair your washing machine, dishwasher, cooker, oven, fridge or any other major domestic appliance
Find a local approved service engineer to repair your

Spares

Appliance spares for washing machines, washer dryers, cookers, ovens, hoods, dishwashers and all other major appliances

Get spare parts in our store

email us on spares@ukwhitegoods.co.uk for spare parts

Or call on 0845 172 8002

Pay for spare parts using all major credit and debit cards and also instant ant payments using PayPal and Amazon for parts

Forum Support

Appliance help and support forums where you can talk to actual domestic appliance engineers about washing machines, cookers, dishwashers, fridge freezers and more
Get help from experts in our forums
Banner

Can't Find It? Need More Help With Your

Getting help, buying spare parts or getting a service engineer for can range from being a simple task to a difficult one as you try to pick your way through model numbers, serial numbers, ranges and all sorts of information. We try to make this as easy as possible for you.

Get technical help for your washing machine, dishwasher, cooker and other appliances in our help and support forums To get technical help with your then please click here for our help and support forums
Get spares help and advice for washing machines, dishwashers, ovens, tumble dryers and more from our spare parts experts Contact us for spare parts using our online contact form, simply click this link to get in touch

Find More Information

Get more information faults, spare parts and repairs using the custom Google search below which will search our forums, the spare parts store and all articles.

Loading


http://sandsspares.co.uk/