Asko WM25 Series Washing Machine Fault Codes

These fault codes apply to later Asko WM25 "Circle Series" washing machine produced in Sweden by Asko, the fault codes for the earlier versions may be similar.

The fault codes below will apply to washing machines from Asko, ISE and Maytag sold in the UK and they will look like the ISE 1606W and 1406W both models employ these fault codes.

Before you start any investigation of the fault or even remove the lid of the washing machine please read and fully understand this article in full and pay particular attention to the safety and information notices at the bottom of this page as they contain extremely important information!

Please remember to support our site by buying spares from our spare part store here and, if you decide that you really need an engineer please support the local repairers that help make this site possible, you can search for a repairer from the link below.

To find an engineer to repair an Asko washing machine just click here

The codes are, from the UK Whitegoods Fault Code Guide are as below.

Asko WM25 Series Washing Machine Fault Codes

These fault codes are written for washing machine repairers and not for the general public by Asko and they assume a certain level of competence on the part of the user in diagnostic routines. We have added some notes to try to assist you in determining the nature of the fault you have but, you will still need to investigate each failure on its own merits. For more help and advice on fault finding on a washing machine please refer to our basic fault finding guide from this link before you begin.

Please check that any Asko washing machine spares recommended are suitable for use on your particular model and serial code. If you are unsure about the suitability of any spare part please ask to ensure that you get the correct spares for your washing machine. Please, don't guess or assume as spares can be altered on a production run with the same model number having several different alternative components used.

The faults marked with an asterix are the top causes of the particular error code being displayed.

These models are very reliable machines and tend not to fail, the biggest single cause of any issues is use or misuse, incorrect detergent, overloading, things blocking the pump and so on. Please check thoroughly before calling an engineer.

More Asko Washing Machine Help, Advice And Guidance

Should you need more help and guidance please use the links from this article as most of them will help you to understand your Asko washing machine a lot better and probably very much help you in diagnosing the fault you have. Of course there are many other articles on the site that will also help you do this.

In addition you can post in our help and advice forums after registering but please do pay heed to the information below before doing so and read the guides, they are there to help you.

You must understand certain things before you begin or attempt any repairs on your own and we want to make these points very, very clear to anyone that decides to investigate one of these or any other washing machines:

• We are not responsible for your safety, you are and by using this guide you accept that and accept that any damage that you may cause and work undertaken is entirely at your own risk.
• We will advise the common causes of the fault codes but we cannot guarantee that any parts or work recommended will resolve the issue. It is entirely your responsibility to diagnose your particular problem and resolve it.
• We are not responsible for you buying spares that do not resolve the problem, this is down to your own diagnosis not ours.
• No warranty is inferred, implied or given.

Please do note that manufacturers can and do change fault codes without notice and we cannot guarantee that these error codes will apply to your particular model as all codes apply to a wide range of appliances and not normally any one specific model. To determine if these fault codes do apply to your particular Asko washing machine model please post a request to confirm this in the forums.