Self Repair Fault Codes Laundry Fault Codes Bosch Logixx WAS Series Washing Machine Error Codes
Bosch Logixx WAS Series Washing Machine Error Codes
There are a number of different version of the electronics used in Bosch Group made washing machines and washer dryers that are sold as Bosch, Siemens and Neff and most of them use the different fault or error codes when they have a problem or a spare part fails. This particular article relates especially to the range of Logixx washing machines that have an ENR number in the format of WAS****GB/** where the asterisks replaced by a number for each one.
The likes of Logixx 8 for example is only a Bosch Logixx series washing machine that has an 8kg rated load capacity, it is not a model number.
So far as we are aware these were used on models from all three Bosch owned brands, Bosch, Neff and Siemens. We have limited information as Bosch does not allow independent repairers access to technical support.
Before you start any investigation of the fault or even remove the lid of the washing machine or washer dryer please read and fully understand this article in full and pay particular attention to the safety and information notices at the bottom of this page as they contain extremely important information!
Please remember to support our site by buying spares from our spare part store here and, if you decide that you really need an engineer please support the local repairers that help make this site possible, you can search for a repairer from the link below.
 |
To find a washing machine engineer to repair a Bosch washing machine just click here |
Bosch Logixx Washing Machine Spares
Please check that any Bosch washing machine spares recommended are suitable for use on your particular model and ENR code. If you are unsure about the suitability of any spare part please ask to ensure that you get the correct spares for your washing machine. Please, don't guess or assume as spares can be altered on a production run with the same model number having several different alternative components used.
In order to ensure you get the correct spare part and, it is very, very easy to get the wrong one as there are a huge number of variants on these machines.
Please contact us prior to ordering to ensure you get the correct Bosch washing machine spares for your particular machine.
To do this you will need, from the rating plate either inside the washing machine door or from that back of it, the following information;
- The full ENR number, this will typically be in the format shown above of WAS****GB/** where the * represents one number
- The is also an FD number, while this is not always required it is better to have it
Not checking this can cost time and hassle, it's worth the time to make sure you get the correct spare part. It also means that, when we check it, we can also check for any compatible spares required and, by using email etc, we can send you parts information if required, images and so on which we cannot do any other way.
Bosch Logixx Washing Machine Fault Codes
These fault codes are written for washing machine repairers and not for the general public by Bosch and they assume a certain level of competence on the part of the user in diagnostic routines. We have added some notes to try to assist you in determining the nature of the fault you have but, you will still need to investigate each failure on its own merits. For more help and advice on fault finding on a washing machine please refer to our basic fault finding guide from this link before you begin.
|
F16 |
Door lock error
|
|
F17 |
Inlet valve error detected
|
|
F18 |
Drain error detected
|
|
F23 |
Antiflood device in base has been activated
|
|
F34 |
Door lock error
|
|
F42 |
Motor fault
|
|
F43 |
Motor fault
|
|
F44 |
Motor fault
|
More Bosch Logixx Washing Machine Help, Advice And Guidance
Should you need more help and guidance please use the links from this article as most of them will help you to understand your Bosch washing machine or washer dryer a lot better and probably very much help you in diagnosing the fault you have. Of course there are many other articles on the site that will also help you do this.
In addition you can post in our help and advice forums after registering but please do pay heed to the information below before doing so and read the guides, they are there to help you.
You must understand certain things before you begin or attempt any repairs on your own and we want to make these points very, very clear to anyone that decides to investigate one of these or any other washing machines:
- We are not responsible for your safety, you are and by using this guide you accept that and accept that any damage that you may cause and work undertaken is entirely at your own risk.
- We will advise the common causes of the fault codes but we cannot guarantee that any parts or work recommended will resolve the issue. It is entirely your responsibility to diagnose your particular problem and resolve it.
- We are not responsible for you buying spares that do not resolve the problem, this is down to your own diagnosis not ours.
- No warranty is inferred, implied or given.
Please do note that manufacturers can and do change fault codes without notice and we cannot guarantee that these error codes will apply to your particular model as all codes apply to a wide range of appliances and not normally any one specific model. To determine if these fault codes do apply to your particular Bosch washing machine model please post a request to confirm this in the forums.
Spare Parts
 |
|
Click here for spare parts in our store email us on spares@ukwhitegoods.co.uk for spare parts Or call on 0845 172 8002 |
Can't Find It? Need More Help With Your Fault?
Buying spare parts for any washing machine or getting a service engineer can range from the simplest task in the world to one of the most daunting as you try to pick your way through model numbers, serial numbers, ranges and all sorts of information. We try to make this as simple as possible for you and take out any hassle but, sometimes, we know that we all need a little help from the experts.
 |
To get technical help for a washing machine then please click here for our washing machine forum |
 |
Contact us for spare parts using our online contact form, simply click this link for our contact page |
Comments
It is showing "fault 17" and I have therefor cleaned both filters back and front..
The machine does get water only when on a prewash waterplus program set to rinse and spin!
I do not understand if the water can get to the drum on one program why does it not on the others.. I am hoping it is not a program fault and if that is the case is that very expensive to mend/replace?
If you ask in the forums someone should be able to help you.
Can you advise
was32460GB/08
RSS feed for comments to this post