ISE CD60 And DV60 Tumble Dryer Fault Codes

These fault codes apply to ISE CD60 (condenser dryer) and DV60 vented tumble dryer models based on the Asko produced TD25 "Circle Series" tumble dryers produced in Sweden by Asko.

The fault codes below will apply to tumble dryers from Asko sold in various countries around the world and Maytag tumble dryers sold in the UK and France.

Before you start any investigation of the fault or even remove the lid of the tumble dryer please read and fully understand this article in full and pay particular attention to the safety and information notices at the bottom of this page as they contain extremely important information!

Please remember to support our site by buying spares from our spare part store here and, if you decide that you really need an engineer please support the local repairers that help make this site possible, you can search for a repairer from the link below.

To find an engineer to repair an ISE tumble dryer just click here

ISE CD60 And DV60 Tumble Dryer Fault Codes

These fault codes are written for tumble dryer repairers and not for the general public by ISE and they assume a certain level of competence on the part of the user in diagnostic routines. We have added some notes to try to assist you in determining the nature of the fault you have but, you will still need to investigate each failure on its own merits. For more help and advice on fault finding on a tumble dryer please refer to our basic fault finding guide from this link before you begin.

Please check that any ISE tumble dryer spares recommended are suitable for use on your particular model and serial code. If you are unsure about the suitability of any spare part please ask to ensure that you get the correct spares for your washing machine. Please, don't guess or assume as spares can be altered on a production run with the same model number having several different alternative components used.

The faults marked with an asterix are the top causes of the particular error code being displayed.

These models are very reliable machines and tend not to fail, the biggest single cause of any issues is use or misuse, overloading, failure to clean filters and condenser units and so on. Please check thoroughly before calling an engineer.

More ISE Tumble Dryer Help, Advice And Guidance

Should you need more help and guidance please use the links from this article as most of them will help you to understand your ISE tumble dryer a lot better and probably very much help you in diagnosing any fault you have. Of course there are many other articles on the site that will also help you do this.

In addition you can post in our help and advice forums after registering but please do pay heed to the information below before doing so and read the guides, they are there to help you.

You must understand certain things before you begin or attempt any repairs on your own and we want to make these points very, very clear to anyone that decides to investigate one of these or any other washing machines:

• We are not responsible for your safety, you are and by using this guide you accept that and accept that any damage that you may cause and work undertaken is entirely at your own risk.
• We will advise the common causes of the fault codes but we cannot guarantee that any parts or work recommended will resolve the issue. It is entirely your responsibility to diagnose your particular problem and resolve it.
• We are not responsible for you buying spares that do not resolve the problem, this is down to your own diagnosis not ours.
• No warranty is inferred, implied or given.

Please do note that manufacturers can and do change fault codes without notice and we cannot guarantee that these error codes will apply to your particular model as all codes apply to a wide range of appliances and not normally any one specific model. To determine if these fault codes do apply to your particular ISE tumble dryer model please post a request to confirm this in the forums.