Announcement

Collapse
No announcement yet.

Aspen 100 oven selector switch broken

Collapse

Qualtex

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Aspen 100 oven selector switch broken

    Hi
    I have a new switch due to a broken spindle but I have no idea how to get to the broken one to replace it.
    Can anyone give me a step by step guide at all?
    Thanks

  • #2
    will need to full model number as there are 20 units with similar numbers. even better would be the 10 digit number off the label which starts either 771 or 772

    Dave

    Comment


    • #3
      Hi, many thanks for the reply
      serial number 1110098903
      model number ap10frsp
      7719986338

      many thanks again

      Comment


      • #4
        the top has to come off

        remove glass lid and hinge supports

        remove screws round each burner and 2 screws holding top down at the rear

        when all loose raise top clear of burners, slide forward and off

        Dave

        Comment


        • #5
          Thanks Dave however this oven doesnít have a glass top.

          currently itís up against the wall in kitchen....do I need access to the back of it?

          Comment


          • #6
            yes you need to get screws at rear

            sorry its got to come out

            dave

            Comment


            • #7
              Ok Iíll try that. So when the top is off the selector switches should be visible?

              chris

              Comment


              • #8
                cook 1.jpgcook 2.jpg

                Comment


                • #9
                  Thanks Dave, is this the same set up as mine? One in the picture looks different or are the switches the same?

                  sorry if I sound a bit slow with this but Iím out of my comfort zone and determined to sort it myself

                  Comment


                  • #10
                    this is the service manual that links with your model. it may be slightly different but essentially the same

                    just take your time and you cant take too many photos as you can always delete them later and that means you can go back if you need to

                    make sure you have correct part before you fit it. the pic above is after the thermostat has been unclipped from the back you can see it in the foreground

                    Dave

                    Comment


                    • #11
                      That's great thank you very much for your help. I'll let you know how it goes

                      Comment

                      Cheap Spare Parts

                      Collapse

                      Affresh

                      Collapse
                      Working...
                      X