Announcement

Collapse
No announcement yet.

Zanussi ZWG 7160 P Fault

Collapse

Qualtex

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Zanussi ZWG 7160 P Fault

    I have a Zanussi ZWG 7160 P not finishing any cycle and won't release the door catch.
    Error code E52 (Tacho coil) is showing, have measured resistance and it's at 174 Ohms when still and rises when I spin the drum by hand. This seems about right (the only info I found said it should be at 184 ohms but the fact it changes seems to mean it's working)
    The machine will rinse and drain but won't spin on any cycle.
    Tried measuring voltage when it's set to spin, but I'm not sure if it's actually trying or not. Either way, only have 56 volts between either brush and earth and nothing on any other cable on the motor connection plug.
    Brushes are fairly worn but not completely gone, I guess I'll change them first but any other advice greatly appreciated.

  • #2
    this is not necessarily a tacho problem all its saying is there is no signal from it and if the motor is not turning there wont be

    fault poss causes listed as

    Wiring faulty; Motor faulty; Main circuit board faulty.

    Dave

    Comment

    Cheap Spare Parts

    Collapse

    Affresh

    Collapse
    Working...
    X