Announcement

Collapse
No announcement yet.

F-10 Error code on an Indesit Wixe127UKTEV Washer

Collapse

Qualtex

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • F-10 Error code on an Indesit Wixe127UKTEV Washer

    Hi, So I've got a F-10 error code as the washer starts to fill, I've checked the pipework to the pressure switch is clear and the pressure switch itself is working ok. I have checked the heating element and the temperature sensor both are working correctly. If I leave the sensor disconnected the washer goes further through it's cycle until I get the F-03 error code (open circuit on the temp sensor). Could it be the control board or has anybody got any other suggestions ?
    Thanks

  • #2

    there is a tech bulletin against this model for the pressure tube rubbing through

    Dave

    Comment


    • #3
      Thanks for your reply Dave I have checked the tube and there are no holes in it

      Comment


      • #4
        well in that case its prob either the pressure sw or the board

        if you have not done it already trace the pressure sw wires to the main board and remove and replace the plus 2 or 3 times to make sure contacts are clean

        Dave

        Comment

        Cheap Spare Parts

        Collapse

        Affresh

        Collapse
        Working...
        X