Cooker & Oven Spare Parts

Buy cooker, hob and built in oven spare parts in our store with many low cost spare parts and get speedy help from our team of oven and cooker part experts who have a vast knowledge of the appliance industry

  Click here to email us and ask us to find any spare part you need and we'll do all the work for you

shop spare parts

User Rating: 1 / 5

Star ActiveStar InactiveStar InactiveStar InactiveStar Inactive
 

Fisher & Paykel oven error codes and spare partsThis set of fault codes for a range of Fisher & Paykel wall ovens (we assume that means built in ovens) and may also cover some other Fisher & Paykel ovens or cookers.

Sadly we do not have a note of the Fisher & Paykel oven model numbers that these error codes relate to.

These error codes may not relate to ALL Fisher & Paykel branded built in ovens.

Before you start any investigation of the fault on your oven or range cooker please read and fully understand this article in full and pay particular attention to the safety and information notices at the bottom of this page as they contain extremely important information!

  Fisher & Paykel Oven Spare Parts

We have purposely not listed any Fisher & Paykel spares in this article as there is a large range of spares used by Fisher & Paykel and, we can't say for sure which models that these codes will relate to.

  Fisher & Paykel Oven Fault Codes

These fault codes are written for oven and cooker repairers and not for the general public by Fisher & Paykel and they assume a certain level of competence on the part of the user in diagnostic routines. We have added some notes to try to assist you in determining the nature of the fault you have but, you will still need to investigate each failure on its own merits. For more help and advice on fault finding on a oven or cooker please refer to our basic fault finding guide from this link before you begin.

A1

CCU did not reset

 

C1

Oven temperature exceeds 305˚C

 

F1

Ambient (room) temperature exceeds 85˚C

 

F2

Meat probe temperature has exceeded 110˚C

 

F4

Shorted or open circuit ambient temperature sensor

 

F5

Short circuit oven temperature sensor

 

F7

Meat probe sensor is short circuited

  More Fisher & Paykel Oven Help

Should you need more help and guidance please use the links from this article as most of them will help you to understand your oven a lot better and probably very much help you in diagnosing the fault you have. Of course there are many other articles on the site that will also help you do this.In addition you can post in our forums after registering but please do pay heed to the information below before doing so and read the guides, they are there to help you.You must understand certain things before you begin or attempt any repairs on your own and we want to make these points very, very clear to anyone that decides to investigate one of these or any other oven or cooker:

  • We are not responsible for your safety, you are and by using this guide you accept that and accept that any damage that you may cause and work undertaken is entirely at your own risk.
  • We will advise the common causes of the fault codes but we cannot guarantee that any parts or work recommended will resolve the issue. It is entirely your responsibility to diagnose your particular problem and resolve it.
  • We are not responsible for you buying spares that do not resolve the problem, this is down to your own diagnosis not ours.
  • No warranty is inferred, implied or given.

Also please understand that fault or error codes are not a "magic bullet", they will not tell you what the problem is, they will only offer you an indication of where the problem lies and they are no substitute for good old fashioned diagnostic skills. You can find out more about what fault codes actually tell you in this article. So please be well aware that, even with this new found knowledge you will still have to actually be capable of investigating and diagnosing the problem and this means adhering to basic appliance safety for working on them. 

Please do note that manufacturers can and do change fault codes without notice and we cannot guarantee that these error codes will apply to your particular model as all codes apply to a wide range of appliances and not normally any one specific model. To determine if these fault codes do apply to your particular Fisher & Paykel oven model please post a request to confirm this in the forums.

Gravatar
Mervyn Bothman
OB90 fisher and paykel oven
Hi , Did a self clean and error codes A2 and A3 came up after the completion of clean with the door staying locked \' turned the power off to reset but know joy
Removed the oven and manually unlocked the door after locating the lock mechanism and powered up.
Noticed an error code F205/F2oS ? not sure if its o5 or os but the oven wont function when selecting any menu , bake/grill etc. but the fan comes on.

Any help will be appreciated.

Cheers Merv


Gravatar
melanie
Fault 215
what does F215 mean on my wall oven?
Gravatar
John
Hi Melanie
I have the same error. How did you fix it?

Gravatar
James Butters
WO600X Built in Oven
My oven has stopped working, it is beeping and shows a code that is either C O or C 0; can you help please?
Gravatar
Urbie
F 7 Code came up when trying to self clean wall oven on Fisher Paykel model OS302 Oven
Gravatar
Urbie
F 7 Code when trying to self clean wall oven on OS302 model. Any suggestions.
Gravatar
Urbie
An F-7 Default code came up when trying to clean my Fisher Payket wall oven model OS302.

1000 Characters left