Dishwasher Spare Parts

Buy dishwasher spare parts in our store at low prices with quick support from our team of dishwasher spare part experts who will help you find and identify dishwasher spare parts

Email us and ask us to find dishwasher parts for you

shop spare parts

User Rating: 4 / 5

Star ActiveStar ActiveStar ActiveStar ActiveStar Inactive
 

Hotpoint dishwasher error codes and spare partsFault or error codes used in dishwashers produced by Indesit for Hotpoint, Ariston and Indesit.

These dishwasher fault codes will displayed as a binary code, exactly as you will see below, using the LEDs in the panel or display on the dishwasher door.

Please try to support our site by buying Hotpoint spares from our store here and, if you decide that you really need an engineer please support the local repairers that help make this site possible, you can find a local dishwasher repair company using our enfineer search facility.

Before you start any investigation of the fault or even remove the lid of the dishwasher please read and fully understand this article in full and pay particular attention to the safety and information notices at the bottom of this page as they contain extremely important information!

  Hotpoint Dishwasher Fault Codes

Like other fault codes these written for dishwasher repairers and not for the general public by Indesit Group and they assume a certain level of competence on the part of the user in diagnostic routines. We may have added some notes to try to assist you in determining the nature of the fault you have but, you will still need to investigate each failure on its own merits. For more help and advice on fault finding on a dishwasher please refer to our basic fault finding guide from this link before you begin.

Please check that any dishwasher spares recommended are suitable for use on your particular model and production code or serial number. If you are unsure about the suitability of any spare part please ask to ensure that you get the correct spares for your Hotpoint dishwasher. Please, don't guess or assume as spares can be altered on a production run with the same model number having several different alternative components used.

  Hotpoint Dishwasher Reset Procedure

It is usually necessary to 'reset' the machine after a fault code has been displayed.  

To reset please follow the steps below.

  • Switch dishwasher off
  • Rotate the selector switch to STOP/CHANGE and switch on
  • After a few seconds the LED’S will go out enabling a new programme to be selected

If an error still exists or persists after this has been carried out then you will have to investigate the fault or call a dishwasher engineer.

  Fault Code Lights Legend

This is our very simple legend to show the state of the lights, lamps or LED's as they are unlit, flashing or lit continuously.

LED or lamp not lit when error is encountered on the dishwasher Light or LED not lit LED or lamp flashing when an error is encountered on the dishwasher Light or LED flashing LED or lamp is lit constantly when an error is encountered on the dishwasher Light or LED lit solid, no flash

  Hotpoint Dishwasher Fault Codes

For this set of dishwasher error codes the lisghts are usually as follows, shown below as corresponding left to right in our fault chart:

Wash = 1
Drying = 2
End = 3
Start/Pause = 4

On most faults the power on/off lamp will be flashing, ignore this.

LED or lamp is lit constantly when an error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

E1 Dishwasher has detected an overflow
  • Internal leak within the dishwasher detected

 

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp is lit constantly when an error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

E2 Dishwasher inlet valve or turbine faulty or disconnected

 

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp is lit constantly when an error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

E3 Thermistor circuit error
  • Thermistor faulty
  • Wiring faulty
  • Control module faulty

 

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp is lit constantly when an error is encountered on the dishwasher

E4 Heating phase timed out
  • Heater open circuit
  • NTC thermistor detached from casing

 

LED or lamp is lit constantly when an error is encountered on the dishwasher

LED or lamp is lit constantly when an error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

E5 Draining the dishwasher has timed out
  • Check drain pump connections
  • Check for a blockage in the drian pump
  • Check control module
  • Check circulation pump

 

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp is lit constantly when an error is encountered on the dishwasher

LED or lamp is lit constantly when an error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

E6 Filling the dishwasher has timed out
  • Check water supply
  • Check water inlet valve
  • Check connections
  • Check timer
  • Check water turbine

 

LED or lamp is lit constantly when an error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp is lit constantly when an error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

E7 Pressure switch error
  • Mesh plate
  • Check filter or microfilter
  • Check pressure switch
  • Check circulation pump

 

LED or lamp is lit constantly when an error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp is lit constantly when an error is encountered on the dishwasher

E8 Software recognition error
  • Module not programmed
  • Wrong keypad installed

 

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp is lit constantly when an error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp is lit constantly when an error is encountered on the dishwasher

E9 Dishwasher heating circuit failure
  • Check dishwasher heating element
  • Check connections
  • Check control module
  • Check heater relay
  • Check dishwasher pressure switch

 

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp is lit constantly when an error is encountered on the dishwasher

LED or lamp is lit constantly when an error is encountered on the dishwasher

E10 Communications error
  • No comms between boards check connections
  • Check electronic control modules

 

LED or lamp is lit constantly when an error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp is lit constantly when an error is encountered on the dishwasher

LED or lamp is lit constantly when an error is encountered on the dishwasher

E11 Non-operative electronic control module
  • Replace control module

 

LED or lamp is lit constantly when an error is encountered on the dishwasher

LED or lamp is lit constantly when an error is encountered on the dishwasher

LED or lamp not lit when error is encountered on the dishwasher

LED or lamp is lit constantly when an error is encountered on the dishwasher

 

E12 Turbine faulty
  • Module has detected no turbine rotation
  • Check turbine and wiring

  More Hotpoint Dishwasher Help, Advice And Guidance

Should you need more help and guidance please use the links from this article as most of them will help you to understand your dishwasher a lot better and probably very much help you in diagnosing the fault you have. Of course there are many other articles on the site that will also help you do this.

In addition you can post in our help and advice forums after registering but please do pay heed to the information below before doing so and read the guides, they are there to help you. But if you are in any doubt at all or don't think you are up to diagnosing the fault yourself please click here to find a local dishwasher engineer.

You must understand certain things before you begin or attempt any repairs on your own and we want to make these points very clear to anyone that decides to investigate one of these or any other dishwashers:

  • We are not responsible for your safety, you are and by using this guide you accept that and accept that any damage that you may cause and work undertaken is entirely at your own risk.
  • We will advise the common causes of the fault codes but we cannot guarantee that any parts or work recommended will resolve the issue. It is entirely your responsibility to diagnose your particular problem and resolve it.
  • We are not responsible for you buying spares that do not resolve the problem, this is down to your own diagnosis not ours.
  • No warranty is inferred, implied or given.

Be aware thatthese Hotpoint dishwasher fault or error codes are not a "magic bullet", they will not tell you what the problem is, they will only offer you an indication of where the problem lies and they are no substitute for diagnostic skills. You can find out more about what fault codes actually tell you in this article. So please be well aware that, even with this new found knowledge you will still have to actually be capable of investigating and diagnosing the problem and this means adhering to basic appliance safety for working on them.

Please do note that manufacturers can and do change fault codes without notice and we cannot guarantee that these error codes will apply to your particular model as all codes apply to a wide range of appliances and not normally any one specific model. To determine if these fault codes do apply to your particular dishwasher model please post a request to confirm this in the forums.

  Applies To Hotpoint Dishwasher Models

These fault codes may apply to models not listed.

Hotpoint Dishwasher

FDL570, FDL570P.R, FDL570P

UWAOMA BLESSING
my dishwasher fdl540
my dishwasher hotpoint fdl540,it on itself when switched on,, the rinse lid,,and sait,,the washing lid(3hrs) keep flashing.pls how do l repaire it.thank you
Kenneth
You would really have to use the forums to get any help with that.
andrew Downing
My Hotpoint FDN550 dishwasher has stopped working properly. Starts as normal but then keeps going but flashes the rinse and salt lamps on left and the three wash/dry /finish lamps on right.. When opened, dishes are semi clean and glasses unrinsed, smokey white deposit.Can u help, A DowningThanks
Mark Ollerton
Our Hotpoint Dishwasher Model LFT114 has stopped working, it seems ot start ok but after a couple of mins a warning sound 2 beeps and then nothing, when opening the display lights are flashing ? Is it terminal ?Thanks
Penny Jones
I have a Hotpoint model E665 the quick rinse light stays on with the number 10 lit.
graeme smith
My hotpoint fdel3101, has stopped working. It is showing the fault code e11 - 134 - is this something i can change myself
graeme smith
I have fault codes 1,3,4 What would advice be
Julie Turnbull
My dishwasher model fdyf 2100Keeps flashing A- 3 doesn't finish the cycle and there is water in the bottom off dishwasher
Julie Turnbull
My hotpoint dishwasher model fdyf 2100 k Keeps flashing A-3 and doesn't finish the cycle,and there is water in the bottom
Paul Harsley
A 3 with water in the bottom
Quote :
My hotpoint dishwasher model fdyf 2100 k Keeps flashing A-3 and doesn\'t finish the cycle,and there is water in the bottom
i am having the exact same problem. Any help would be appreciated. Julie, did you find a solution?

Thanks! Paul

1000 Characters left